focus lpos Configures the thermal head to fix the specified lens-position. The thermal head focus is configured for mode 1 ( fixed lens-position mode ). This command is intended to aid the flexo project setup the second stage focus adjustment. The thermal head is fixed at a lens-position that is consistent with the command "head install on" and the second stage focus adjustment is set to simulate the thickness of Kodak IR plates. As a result, the thermal head will think it is imaging media with a thickness of ~305um while in fact the thickness is >1cm. focus lpos on <position> Enables the fixed lens-position mode at the position specified by <position>. The position is an integer ranging from -500um to 500um. focus lpos off Disables the fixed lens-position mode. Thermal focus lpos (on <position>|off) Fixed lens-position mode has been implemented in thermal head firmware version 1.30 and above.

../commands/focus.xmlCommand: focus

NVS:

../nvs/hdm_cal_fmode.xmlNVS: hdm fmode

NVS:

../nvs/head_cfg_fsample.xmlNVS: head fsample

..\..\ShowAllErrors.htmFirmware 0 Error Index ..\..\ShowAllCommands.htmFirmware 0 Command Index ..\..\ShowAllNVS.htmFirmware 0 NVS Index Updated: Wed Jul 16 19:39:01 2008 PST